River reaches

Continuous parts of streams between two specified points.
This category is also used for reaches (hydraulic) and reaches (streams).
Subtopics:
(none)
Related topics:

13 results listed by similarity [list alphabetically]
Sediment grain size from the Elwha River, Washington, 2006 to 2017

The grain size of sediment on the riverbed was measured during 20 surveys on the Elwha River, Washington, between 2006 and 2017. Most data were collected along the same transects where channel topography was measured (see related child item in this data release: https://www.sciencebase.gov/catalog/item/5a989288e4b06990606de04b). Measurements of sediment ranging from medium sand to boulders were made using the CobbleCam digital photographic technique (Warrick and others, 2009), which uses a calibrated ...

Info
River-channel topography on the Elwha River, Washington, 2006 to 2017

This portion of the data release presents topographic data collected at 5 study sites along Elwha River, Washington between 2006 and 2017. Elevations along channel-perpendicular transects were surveyed using a total station and prism rod. Initial geodetic control was established using static global positioning system (GPS) occupations. A total station was subsequently used to expand and maintain the survey control network at each site. All survey data were referenced to the NAD83 datum, using the UTM, zone ...

Info
Monthly bedload estimates, Elwha River, Washington, October 2015 to September 2016

Bedload sediment transport was calculated on the Elwha River, Washington to measure the amount of sediment transported along the riverbed during the 2016 water year. Bedload was measured using the Elwha bedload impact plate system (Hilldale and others, 2015). Physical bedload sampling by the U.S. Bureau of Reclamation for system calibration took place during November, 2012; March, May, and June 2013; and April 2014 at the Diversion Weir gauge (Magirl and others, 2015). Early in water year 2016 (year 5) the ...

Info
Orthomosaic images of the middle and lower Elwha River, Washington, 2012 to 2017

This dataset presents 28 georeferenced orthomosaic images of the middle and lower reaches of the Elwha River. Each mosaic image was created by stitching together thousands of individual photographs that were matched based on numerous unique tie points shared by the photographs. The individual photographs were taken by a plane-mounted camera during multiple flights over the study area spanning 2012 to 2017. Because each mosaic is orthogonal to the earth's surface and is georeferenced to real-world ...

Info
Digital elevation models (DEMs) of the lower Elwha River, Washington, water year 2013 to 2016

Digital elevation models (DEMs) of the lower Elwha River, Washington, were created by synthesizing lidar and PlaneCam Structure-from-Motion (SfM) data. Lidar and still digital photographs were collected by airplane during surveys from 2012 to 2016. The digital photographs were used to create a SfM digital surface model. Each DEM represents the ending conditions for that water year (for example, the 2013 DEM represents conditions at approximately September 30, 2013). The final DEMs, presented here, were ...

Info
Elevations of the Elwha and Mills dams, Elwha River, Washington, 2008 to 2013

This dataset presents elevation measurements of two dams on the Elwha River, Washington, during their removal processes from 2008 to 2013. Elevation measurements of the Elwha Dam were taken from October 2008 to March 2012. Elevation measurements of the Glines Canyon dam, which was further upstream than the Elwha Dam, were taken from October 2010 to October 2013. The measurements were by the U.S. Bureau of Reclamation as part of a study investigating the river channel's morphological responses to dam removal ...

Info
Upstream sediment contributions to Lake Mills on the Elwha River, Washington, 1926 to 2016

Sediment inputs to Lake Mills, on the Elwha River, Washington, were measured from 1927 to 2016. These measurements represent the annual total sediment load, in tonnes per year, that were input into Lake Mills and partially trapped by Glines Canyon dam. The sediment was allowed to erode and be transported down-river by the removal of the Glines Canyon and Elwha dams during 2011 to 2014. The measurements were taken as part of a study investigating the river channel's morphological responses to the removal of ...

Info
Streamgage measurements, Elwha River, Washington, 2011 to 2016

Streamgage levels on the Elwha River were measured from 2011 to 2016. These measurements show the height of the river's water surface, both in meters relative to the stream bed, as well as in meters relative to vertical geographic coordinates. Measurements were collected using a Global Water WL16 battery-operated vented water level logger in a hardened casing. The instrument was installed on October 17, 2011 on the left bank of the Elwha River at a power line crossing above the Elwha Surface Water Intake ...

Info
Turbidity data from the Carmel River, central California, 2014 to 2017

This data provides river turbidity measurements collected on the Carmel River, CA. Turbidity was measured to study any changes in the Carmel River’s sediment loads following the removal of the San Clemente Dam. The USGS-run DTS-12 turbidity sensor was deployed above the Sleepy Hollow Weir on the Carmel River, CA (instrument was located at 36.445250 degrees North, 121.710494 degrees West). Deployment began on December 9, 2014. After June 16, 2016, the instrument was removed for calibration. A new ...

Info
Grain size data from the Carmel River, central California, 2013 to 2021 (ver. 2.0, March 2022)

Pebble-count data were collected during summer surveys (2013, 2015, 2016, 2017, 2018, 2019, 2020, and 2021) at ten sites along the Carmel River, California. Grain-size measurements were made at four to six transects per site using a 0.5 by 0.5 m sampling frame, with approximately 100 sediment-particle counts per transect. Each transect was defined by coordinates on the left and right sides of the river, and sediment grain sizes were measured at five equally spaced locations within the bankfull channel on ...

Info
Topographic survey transect data along the Carmel River, central California, 2013 to 2021 (ver. 2.0, March 2022)

Topographic surveys were completed during eight summer surveys (in 2013, 2014, 2015, 2016, 2017, 2019, 2020 and 2021) at 10 sites along the Carmel River, CA: Berwick (BW), Control Reach (CR), Crossroads (CRO), DeDampierre Lower (DDL), DeDampierre Upper (DDU), Dam Reach (DM), Reservoir Reach (RS), San Carlos (SC), Sleepy Hollow (SH), and Schulte Road (SR)). Topographic measurements were made at multiple locations along four to six cross-section transects per site using a total station (at sites CR, RS, DM ...

Info
Topographic survey transect endpoint coordinates along the Carmel River, central California, 2013 to 2021 (ver. 2.0, March 2022)

This dataset contains the easting, northing, and elevation values of the river-right and river-left transect endpoint reference benchmarks (RBM and LBM) from survey transects at 10 survey reaches along the Carmel River, central California. Topographic surveys were completed on these transects during eight summer surveys (in 2013, 2014, 2015, 2016, 2017, 2019, 2020 and 2021). See accompanying file within this data release for elevation measurements. All data were collected in NAD83 UTM10N horizontal ...

Info
High resolution topography for two pools on the Carmel River, central California, 2014 to 2019

High-resolution topographic surveys were conducted at two pools on the Carmel River between 2014 and 2019 using a survey-grade total station. The Dam Reach pool (DMPOOL) is located within the Dam Reach, approximately 450 meters downstream of the former site of the San Clemente Dam. The Sleepy Hollow pool (SHPOOL) is located within the Sleepy Hollow reach, approximately 2.25 kilometers downstream of the former site of the San Clemente Dam. Both pools were surveyed in 2014, 2015, 2016, 2017, and 2019 using a ...

Info