Currents

used for all ocean currents in the nearshore environment, including longshore, tidal, and rip currents.
Subtopics:
Tidal currents (2 items)

8 results listed alphabetically [list by similarity]
Current profiler time-series data collected in 2009 offshore of Wainwright, Alaska

A time-series of binned current-velocities and recorded ping amplitudes were collected offshore Wainwright, Alaska, from August 24 to October 02, 2009 (UTC). Measurements were collected using a 1 MHz NortekTM AWAC acoustic Doppler current profiler mounted on a frame in approximately 10 m of water. The profiler was mounted on the frame 0.55 m off the bottom of the seafloor, and collected data in 8 vertical bins, centered at 1.95(bin1), 2.95, 3.95, 4.95, 5.95, 6.95, 7.95, and 8.95(bin8) meters above the ...

Info
Discharge measurements collected in the Stillaguamish River Delta, Port Susan, Washington, USA in March, April, and May 2014

Tidal water discharge within two breaches constructed in a former flood-control levee of a restored agricultural area in Port Susan, Washington, was measured repeatedly during several tidal cycles. Measurements were made on March 27, 2014, April 16, 2014, May 18, 2014, and May 29, 2014 at breach PSB1, and on May 29, 2014 at breach PSB2. These data were collected using a boat-mounted Teledyne RDI RiverRay 600 kHz acoustic Doppler current profiler (ADCP) or a Teledyne RDI StreamPro 2000 kHz ADCP, depending on ...

Info
Lagrangian drifter data from the mouth of the Columbia River, Oregon and Washington, 2013

Lagrangian surface currents were measured using drifters equipped with global navigation satellite system (GNSS) receivers. A total of 8 drifter deployments were performed between May 25 and June 8, 2013. For each deployment, drifters were released within the MCR and their positions were recorded until the drifters were recovered. The average duration of the drifter deployments varied between 1.6 h and 17.2 h and the number of drifters released in a deployment ranged between 11 and 84. The initial positions ...

Info
Oceanographic time-series measurements collected in the Stillaguamish River Delta, Port Susan, Washington, USA from March 2014 to July 2015

Water level, flow velocity, temperature, salinity, and turbidity were measured in a breach constructed in a flood-protection levee surrounding a restored former agricultural area in Port Susan, Washington, USA, near the mouth of the Stillaguamish River. Data were collected in a breach known as PSB1 at 15-minute intervals from March 21, 2014 to July 1, 2015 using a SonTek Argonaut-SW current meter, an In-Situ Aqua TROLL 200 pressure, conductivity, and temperature sensor, and an FTS DTS-12 turbidity sensor.

Info
Oceanographic time-series measurements from the mouth of the Columbia River, Oregon and Washington, 2013

Time-series data of water surface elevation, wave height, and water column currents, temperature, salinity, and acoustic seabed images were acquired for 38 days between 9 May and 15 June, 2013 in the mouth of the Columbia River, Oregon and Washington.

Info
Physics-based numerical circulation model outputs of ocean surface circulation during the 2010-2013 summer coral-spawning seasons in Maui Nui, Hawaii, USA

Ocean surface current results from a physics-based, 3-dimensional coupled ocean-atmosphere numerical model were generated to understand coral larval dispersal patterns in Maui Nui, Hawaii, USA. The model was used to simulate coral larval dispersal patterns from a number of existing State-managed reefs and large tracks of reefs with high coral coverage that might be good candidates for marine-protected areas (MPAs) during 8 spawning events during 2010-2013. The goal of this effort is to provide geophysical ...

Info
Vessel-mounted acoustic Doppler current profiler (ADCP) data from the lower Columbia River, Washington and Oregon, 2021

This dataset contains water velocity data derived from spatial surveys performed with a vessel-mounted acoustic Doppler current profiler at four sites (SKM, SLG, LDB, WLW) in the lower Columbia River, Washington and Oregon, in 2021. The data are provided in netCDF (.nc) format and compressed into .zip archives for each site.

Info
Vessel-mounted acoustic Doppler current profiler (ADCP) data from the mouth of the Columbia River, Oregon and Washington, 2013

Spatial surveys of water column currents were performed between June 14 and 16, 2013, in the mouth of the Columbia River, Oregon and Washington. These data were collected using an acoustic-doppler current profiler (ADCP).

Info