Bathymetry data were collected in the Wainwright Inlet, the mouth of the Kuk River, and in the nearshore region off Wainwright, Alaska, in August of 2009. Bathymetry was measured with a single-beam echo-sounder (10 Hz 144 ODOM Echotrac CV-100) mounted on the stern of a small vessel and synchronized to a 145 Real-Time Kinematic (RTK) Global Positioning Systems (GPS). The depth is measured relative to approximate Mean Sea Level (see attribute accuracy report in this file for further details on the MSL), and ...

This part of the data release presents acoustic backscatter data collected on February 1, 2011, in the Sacramento River from the confluence of the Feather River to Knights Landing. The data were collected by the USGS Pacific Coastal and Marine Science Center (PCMSC) team with collaboration and funding from the U.S. Army Corp of Engineers. This project used interferometric sidescan sonar to characterize the riverbed and channel banks along a 12 mile reach of the Sacramento River, California (River Mile 79 ...

This part of the data release presents a digital elevation model (DEM) created from bathymetry data collected on February 1, 2011, in the Sacramento River from the confluence of the Feather River to Knights Landing. The data were collected by the USGS Pacific Coastal and Marine Science Center (PCMSC) team with collaboration and funding from the U.S. Army Corps of Engineers. This project used interferometric sidescan sonar to characterize the riverbed and channel banks along a 12 mile reach of the Sacramento ...

This part of the data release contains a grid of standard deviations of bathymetric soundings within each 0.5 m x 0.5 m grid cell. The bathymetry was collected on February 1, 2011, in the Sacramento River from the confluence of the Feather River to Knights Landing. The standard deviations represent one component of bathymetric uncertainty in the final digital elevation model (DEM), which is also available in this data release. The bathymetry data were collected by the USGS Pacific Coastal and Marine ...

Beach and foreshore elevation data were collected in the vicinity of Wainwright, Alaska. The area from the mouth of the Kuk River to about 8 km to the northeast was measured in August 2009. The area from the mouth of the Kuk River to about 5 km to the northeast was measured in October 2009. The elevation data were collected with Real-Time Kinematic (RTK) Global Positioning System (GPS) systems mounted on all-terrain vehicles. The GPS sampling rate was 1 Hz with vehicle speeds maintained at less than 15 km ...

Measurements of conductivity and temperature were collected with a high-accuracy conductivity and temperature recorder (Seabird SBE37 microcat) in approximately 10 m water depth at a single location fronting the village of Wainwright, Alaska, from 24 August to 1 October 2009. The instrument was mounted on the frame approximately 0.50 m off the bottom of the seafloor. Salinity was calculated from conductivity measurements.

Measurements of conductivity, temperature, and depth (CTD), in addition to dissolved oxygen, nitrogen, and fluorescence, were collected in the Wainwright Inlet, the mouth of the Kuk River, and in the nearshore region off Wainwright, Alaska, in August 2009 with a Seabird SBE 19. Post-survey calculations of salinity were made from the conductivity measurements.

A time-series of binned current-velocities and recorded ping amplitudes were collected offshore Wainwright, Alaska, from August 24 to October 02, 2009 (UTC). Measurements were collected using a 1 MHz NortekTM AWAC acoustic Doppler current profiler mounted on a frame in approximately 10 m of water. The profiler was mounted on the frame 0.55 m off the bottom of the seafloor, and collected data in 8 vertical bins, centered at 1.95(bin1), 2.95, 3.95, 4.95, 5.95, 6.95, 7.95, and 8.95(bin8) meters above the ...

Grain-size data, including grain size, cumulative frequency, and median, was determined from samples collected at three bluff locations in the vicinity of Wainwright, Alaska. The different locations (termed W1, W2, and W3) represent three different slope-failure modes. Sediment grab samples for most bluff locations were collected in August 2009, while sediment samples from the bluff at site W3 and multiple foreshore locations were collected in September and October of 2009. Two of the grab samples were ...

Sediment grab samples were collected at 158 locations on the foreshore and beach in the vicinity of Wainwright, Alaska, in October of 2009. Two of the grab samples were sieved and analyzed for grain size distributions. The grain-size distribution of the remaining samples was determined from referenced photographs of collected samples taken in the lab following the method of Barnard and others (2007) using two-dimensional spectral decomposition of sediment images (Buscombe and others, 2010). Results of ...

A time-series of varying water depths were collected offshore of Wainwright, Alaska, from August 23 to October 02, 2009 (UTC). Measurements were collected with a built-in pressure transducer from a 1 MHz NortekTM AWAC acoustic Doppler current profiler mounted on a frame in approximately 10 m of water. The instrument was mounted to the frame at 0.55 m off the bottom of the seafloor. Reported depth values include the 0.55 m offset, and thus are depths relative to the seabed. These data are available in a ...

Time series wave data were collected offshore of Wainwright, Alaska, from August 24 to October 02, 2009 (UTC). Measurements were collected using a 1 MHz NortekTM AWAC acoustic Doppler current profiler mounted on a frame in approximately 10 m of water. The instrument was mounted to the frame at 0.55 m off the bottom of the seafloor, and collected data in 8.53-minute bursts at 2 Hz. Significant wave heights (Hs), maximum significant wave heights (Hmax), peak and mean wave periods (Tp and Tm, respectively), ...