Grain size of bulk sediments from the Escanaba Trough, off the coast of Northern California, USA, from May-June 2022.

SEDIMENT COLLECTION. Samples were collected aboard the R/V Thomas Thompson via push coring using the ROV Jason. Once recovered shipboard, pore waters were extracted via rhizon samplers, cores were subsectioned into one to five cm slices, the exterior sediment which was in contact with the core liner was removed, and remaining sediment was stored frozen in pre-combusted glass jars.

GRAIN-SIZE ANALYSIS: Grain-size analysis was conducted by the USGS Pacific Coastal and Marine Science Center (PCMSC) sediment lab using a Beckman Coulter LS 13 320 particle size analyzer with an aqueous liquid module attachment. PCMSC procedures are modified from those described in Carver (1971) and Folk (1974, 1980). 5-50 grams of sediment was sub-sampled and at least 10 milliliters of 30 percent hydrogen peroxide were added to oxidize overnight to remove organics. The samples were then heated to 250 degrees Celsius to drive off excess hydrogen peroxide. Next, samples were placed in an ultrasonic bath to help disperse silt and clay (mud) from sand and larger-sized particles. Samples were then rinsed twice in deionized water with centrifugation to remove soluble ions. Subsequently, the samples were wet sieved with 1 millimeter and 0.063 millimeter sieves to segregate the combined gravel and coarse sand fraction (greater than 1 millimeter), sand (1 millimeter to 0.063 millimeter), and mud (less than 0.063 millimeter). The coarse sand + gravel fractions were then dried, dry sieved at 1/4phi intervals and weighed (Carver, 1971). The sand fraction was dried and weighed. The mud fraction was collected in a 1 liter graduated cylinder, 5 milliliters of at least 10 percent sodium hexametaphosphate (dispersant) were added, and deionized water was added to bring the total the volume to 1 liter. The mud + dispersant solution sat overnight to ensure complete dispersion and to observe if flocculation occurred. Subsequently, a 20 milliliter aliquot was extracted from the graduated cylinder and dried to obtain the mud fraction weight normalized to a 1-liter basis. The mud and sand fractions were analyzed separately via the Beckman Coulter LS 13 320 with the aqueous liquid module attachment. All size fraction data were compiled and converted by the PCMSC sediment lab pcSDSZ program (Penscil, 2015) to a grain-size distribution at 1/4phi size intervals on a weight percent basis. pcSDSZ also calculated interpolated sizes and graphical statistics on a percent coarser basis (Folk and Ward, 1957; Folk, 1966; Folk, 1974, 1980; Inman, 1952; Trask, 1930, 1932) and moment measures (Collias and others, 1963; Jaquet and Vernet, 1976; Folk, 1980).